[MLB-WIRELESS] Surge Protection

[Clae]

>  Are any of you guys running some sort of lightning protection? If so please
>  give some details!
>

Never have the antenna higher than the pole.  Leave at least 30 cm
of pole above the antenna.

Gound the pole to a good ground such as a water pipe or ground rod
or both.  Use at least a 2mm line and much larger if you can find
some.  If its to spec, the wire will be green and yellow (unless
its a telco which uses purple)

It depends on if your in a high risk area or not.  If your in a
high risk area, you may want a second higher pole.  If your at risk
of a major hit, you need to have a high current line from ground(s)
to the top of the pole.  On HVC and JAD I have 10mm gound lines to
good grounds.  HVA is in a hole with three taller buildings near
by so its simply floating.

HVC does get hit from time to time.  At HVC I use a surge arrestor
that cost about $80 that is a bunch of high voltage clamps.  Others
have reported that the device works well enough to limit damage to the
ethernet transciver chips so they might have a PC or router.

Keep in mind that lightning starts on the ground and goes up but
once the current starts going other paths will be found.

-tim
http://web.abnormal.com

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message
-- 
_____________________
"When in doubt, make a fool of yourself. There is a microscopically 
thin line between being brilliantly creative and acting like the most 
gigantic idiot on Earth. So what the hell, leap! " - Peter McWilliams


To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message