[MLB-WIRELESS] OSPF Area IDs and IP blocks / Quagga

[Dan Flett]

Hi,

Can anyone provide a list of the address ranges for each Locfinder Area
that the node IP Block Allocations come from?

For instance, here in RGSouthern our IP addresses all seem to fall
within 10.10.144.0/22.  Is this correct?

All our Quagga setups are using Area 0 as there no need for us to use
Area 10 hasn't arisen yet (network isn't big enough).  If we were to be
connected to, say, RGOuterEasten, would we need to config our local
routers to:

(from ospfd.conf)
network 10.10.144.0/22 area 0.0.0.10?


At the moment, I find that it's sufficient to put

router ospf
 ospf router-id 10.10.145.45
 redistribute connected
 network 10.10.0.0/16 area 0.0.0.0 

in ospfd.conf to get things working.

After playing with Quagga config files I've found it's not necessary to
specify ip addresses or local networks in either zebra.conf or
ospfd.conf
You only need to specify the names of network interfaces.  This means
two less files you have to edit if you change an IP address on an
interface in your box.  The 'ospf router-id 10.10.145.45' also doesn't
seem to be critical - it's just a reference for humans reading the
output of Quagga's OSPF routing table to see the addresses of OSPF
routers on the network.  The network won't break if it's set to
something else.

Basically what I'm doing is trying to work out the minimum level of
configuration that Quagga needs to work on our network.

Dan

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message