[MLB-WIRELESS] Linksys Alchemy-pre5.1 v2.07.1.8sv firmware question.

[Johnno]

thx Andrew but still no go :(
I tried all combos, mixed, 54, 11....just wont connect
what ver firmware are you using there?


----------------------------------
Regards
John
----------------------------------




----- Original Message ----- 
From: "Andrew Leech" <a_leech at swin.edu.au>
To: "Johnno" <fromjohnno at hotmail.com>
Cc: <melbwireless at wireless.org.au>
Sent: Sunday, August 08, 2004 6:53 PM
Subject: Re: [MLB-WIRELESS] Linksys Alchemy-pre5.1 v2.07.1.8sv firmware
question.


> I had difficulty getting it to work initially in client mode myself. It
was basically a trial and error method of getting this set up, as I assume
you found out there is next to no info about it on the sveasoft pages.
>
> The ap I'm associating with has dhcp running, and I had to turn off the
dhcp server on the client mode wrt first, then enable client mode. Once
client mode is enabled, I made sure I had the exact ssid in the box, and I
set the ip address in the box below to the ip of the ap associating with.
When associating with an ap in B mode, not G, I had to explicitly set it to
B mode rather than mixed.
>
> Then go to the status page, then on the wireless sub-page, it will report
when it's associated and gives the signal strength and noise levels as a
bottom line called 'AP Signal'. THis line isn't there at all when not
associated.
>
> In client mode, the ap acts as a wireless bridge, so a computer plugged
into the switch on the back of the client mode ap can get dhcp from the
associated ap. Or if you're using static ip's, the computer set to the same
subnet as the associated ap should be able to ping it.
>
> Hope this helps...I'm thinking your trouble might most likely be the B
mode rather than mixed setting, it caught me for some time.
>
> Andrew
>
>
> On Sun, 8 Aug 2004 17:31:05 +1000, Johnno <fromjohnno at hotmail.com> wrote:
>
> > I'm using the above firmware on a Linksys wrt54g ver2
> > I am having trouble running it in client mode.....
> > just wont connect with the AP.
> >
> > anyone used it in client mode ?
> >
> >
> > John
> >
> > To unsubscribe: send mail to majordomo at wireless.org.au
> > with "unsubscribe melbwireless" in the body of the message
> >
> >
>
>
>
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
>
>

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message