[MLB-WIRELESS] GDW -> GHO

[Richard Van Orsouw]

Too bad you couldn't send me a veritech on wednesday's order to melbourne :)


> ----------
> From: 	Jamie Moir
> Sent: 	Tuesday, 10 June 2003 10:35 AM
> Cc: 	'melbwireless at wireless.org.au'
> Subject: 	Re: [MLB-WIRELESS] GDW -> GHO
> 
> 
> On Tue, 10 Jun 2003, Richard Van Orsouw wrote:
> 
> > I am either going to replace the entrasys card with a veritech 200mW or
> I
> > have a Cisco AP1200 which I might run in client AP mode. Does any know
> where
> > I can get a pigtail for it, I believe it uses a RF-TNC ?
> 
> I have reverse gender TNC pigtails for $27 if you dont get a local source.
> 
> > was also suggested trying mtu/ttl values. This problem I am experiencing
> is
> > most likely due to the poor rx from gdw to gho, but it also could be a
> > timing issue due to the long round trip delays ( since my link is 64km
> plus
> > another 20km to the other nodes). Any suggestions on values I could try
> > would be appreciated.
> 
> 64km is really an impressive link, I think Perth is largely too flat for
> that =)
> 
> Jamie
> 
> 
> To unsubscribe: send mail to majordomo at wireless.org.au
> with "unsubscribe melbwireless" in the body of the message
> 
> 

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message