[MLB-WIRELESS] Using the Node Dbase

[Richard Van Orsouw]

I don't quite understand Tony, if all nodes are on the same network, why
would I need routing ?. At this stage I'm just experimenting with this since
I am only a newbie. Once I have all four nodes connected together, I will
then look at networking with other nodes.

Cheers,

Richard.

> ----------
> From: 	Tony Langdon
> Sent: 	Friday, 19 July 2002 1:35 PM
> To: 	Richard Van Orsouw; 'Drew'
> Cc: 	'melbwireless at wireless.org.au'
> Subject: 	RE: [MLB-WIRELESS] Using the Node Dbase
> 
> > Ok guys this is what I want to do.
> > 
> > Have one node setup with an Omni and three other nodes with 
> > directionals all
> > using IBSS, same SSID, same channel.
> > Does this sound fesible. (before i rush out and buy a $500 AP).
> 
> Use routing instead of bridging.  This is a bit similar to the scenario we
> setup at the last meet where not all nodes could see each other, but OSPF
> was able to allow them to find an open route between them via intermediate
> nodes.  
> 
> Or the routing could be statically configured, if it doesn't change at
> all.
> 
> This correspondence is for the named person's use only. It may contain
> confidential or legally privileged information or both. No confidentiality
> or privilege is waived or lost by any mistransmission. If you receive this
> correspondence in error, please immediately delete it from your system and
> notify the sender. You must not disclose, copy or rely on any part of this
> correspondence if you are not the intended recipient.
> 
> Any opinions expressed in this message are those of the individual sender.
> 
> 

To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message