[MLB-WIRELESS] OT: Question for a Genuis (CPU Q)

[lkhoo at csc.com.au]

Michael,
      We're currently trying to do a group buy for some SLOT-T adapters.
Tualatin P3/Celeron adapters and MUCH cheaper prices that those powerleap
ones ($66 but we'll get cheap ~$55 I think buying bulk).

http://forums.overclockers.com.au/showthread.php?s
=&postid=1372482#post1372482

These seems to only support the v2 rev of your board as you said.
http://www.upgradeware.com/english/product/slot-t/compatibility.htm

Have you tried to use one of the older celeron 2's? ie. 600+ with a older
slocket? I am currently using a Celeron 600(@1ghz) in a very old Abit BH6
v1.0 (old slot 1 mb from the Celery 300A era).
Frequency multiplers have been locked in these cpu's for ages so what the
bios can do doesn't really matter. its just the FSB that you change.
As for voltage many of the slockets allow you to specify the voltage
supplied to the cpu as you said so it should *probably* work.


Lucas

-----Original Message-----
From: owner-melbwireless at wireless.org.au
[mailto:owner-melbwireless at wireless.org.au]On Behalf Of Matt Pearce
Sent: Thursday, 5 December 2002 9:33 PM
To: melbourne wireless
Subject: [MLB-WIRELESS] OT: Question for a Genuis (CPU Q)


Hi All,

I have a question with regards to installing a new CPU in a motherboard,
the
mobo is a Gigabyte GA-6BXC with a BX440 chipset.  Now the FAQ on there
website says that the coppermine series of CPU is not supported on my mobo
revision (1.6), but it says after version 2.0 that the coppermine is
supported.  The FSB can be clocked to 133 and the online manual says that I
can run the frequency multiplier to 9.5 this gets a theoretical high of
1.26Ghz on a slot 1 mobo, which is pretty good if I can get it to run.

Now the question is, is the coppermine not supported cause the mobo is not
capable of lowering the voltage sufficiently(currently running a PIII
550Mhz@ 2v) to run say a PIII 1.26Ghz Tualatin(1.45v) CPU or is there
something else I am not seeing ??

If it is only the voltage I can get a converter card that is flexible
enough
to lower the voltage so it should run, will this work ??

If this actually works it could have some very good implications for other
users to ramp up speed for very low cost :-)

Thanks in advance for any help and sorry for the off topic post.

Matt





To unsubscribe: send mail to majordomo at wireless.org.au
with "unsubscribe melbwireless" in the body of the message